From QB64 Wiki
The FOR statement creates a counter loop using specified start and stop numerical boundaries. The default increment is + 1.
- The FOR counter_variable name is required to define the counter span and may also be used after the NEXT keyword.
- The start_value TO stop_value can be any literal or variable numerical type. BOTH values are required!
- STEP can be used for a loop increment other than the default 1 and can be any positive or negative literal or variable numerical value.
- NEXT ends the FOR loop code block and increments the counter to the next value even when it exceeds the stop limit.
- FOR NEXT counter loops must be within the proper start, stop and increment values or the entire loop code block will not be executed.
- Avoid changing the FOR counter_variable's value inside of the loop. This obfuscates code and is a poor programming practice!
- Once the loop has been started, changing the start_value, stop_value or increment value will not affect loop execution.
- If the STEP increment value does not match the start_value TO stop_value the FOR loop block will be ignored!
- Use EXIT FOR to leave a FOR loop early when a certain condition is met inside of the loop.
- The NEXT counter variable name is not required. NEXT loop increments can be separated by colons in nested FOR loops.
- NOTE: The counter value AFTER a FOR loop will be incremented one more than the stop_value requested by the loop!
Example 1: Adding all of the even numbers from 10 to 0.
FOR i = 10 TO 0 STEP -2 totaleven% = i + totaleven% PRINT totaleven%; NEXT PRINT "After loop, i ="; i
10 18 24 28 30 30 After loop, i = -2
- Explanation: The loop counts down from 10 to every even value below it. The counter keeps stepping down until the FOR stop limit is reached or exceeded. Note that the value of i is -2 after the loop is exited. NEXT always increments the counter one last time.
Example 2: How an entire FOR loop block is ignored when the start and stop limits do not match the default or STEP increment.